NUMARK DJ2Go... configuration

Lolli · July 01, 2015, 12:07:42 AM

I took Jumpin' Jeff's advice and got the Numark DJ2Go controller... Only problem is, it isn't working!

Here's what I have done:
1.went to OPTIONS/MIDI and configured the input settings to DJ2Go
2. left the others as they were.

The controller does not respond. When I plug it in the lights flicker once but that's as much life as I can get out of it.

I've enabled the controller in the settings but still no joy

Can you help please?

Thank you

Jumpin' Jeff · July 01, 2015, 12:29:09 AM

So you didn't select a MIDI map for the DJ2Go?

Lolli · July 01, 2015, 12:38:22 AM

Hi Jeff.
No, there isn't one in there for the Numark

Jumpin' Jeff · July 01, 2015, 12:39:37 AM

Then you need to put one in there, and relaunch Ots, and then select it before Ots will respond to it.

Lolli · July 01, 2015, 12:43:24 AM

sorry, but how can I "put one in there" if it's not available to pre-select??
Sure it will be obvious when you tell me, but right now I can't see it!

Richie

Jumpin' Jeff · July 01, 2015, 01:19:26 PM

Easiest way is to close Ots, go to the location you installed Ots to, which by default is C:\OtsLabs\, open the data folder, then the OHML folder (C:\OtsLabs\Data\OHML\, and place the file I provided in the other post into this location. Launch OtsAV, and then enter the MIDI configuration panel, and this new file should now be selectable in the map selector box. Once enabled, it should now work as configured.

Lolli · July 01, 2015, 01:38:45 PM

Hi Jeff. Only the sliders work, not the play or cue buttons

Jumpin' Jeff · July 01, 2015, 01:45:34 PM

I was sure I gave you the correct map, but perhaps not. I don't have the device in front of me currently, so I won't be able to update you until tonight. I will verify the map and re-post it.